If you’re stuck and looking for how to reboot the Zealot P2 Bluetooth speaker, then you’re in the right place. You’re not alone—I’ve been there too. I ran into this exact issue and trust me, 90% of the advice online was either misleading, half-baked, or completely useless.
Let me save you the stress I went through.
What Happened to My Zealot P2?
I took my Zealot P2 to a kids’ event. First, I connected it to my laptop so they could watch a movie. All was going fine—the speaker worked perfectly, loud and clear.
After the movie, I turned off the laptop and connected the speaker to my phone to play music for the kids. Again, no issues.
But here’s where the drama started: when it was time to leave and I tried to turn the speaker off, it just refused to power down. The power button did absolutely nothing. I hit the Mode button—no response. I even disconnected it and left it idle, hoping it would auto-shutdown. Nada.
It was stuck.
My Search for Answers (and Frustration)
Naturally, I went online and searched for how to reboot the Zealot P2 Bluetooth speaker. What I found were a bunch of articles with recycled nonsense.
- “Hold the power button for 30 seconds” – didn’t work.
- “Look for a reset hole” – there’s none.
- “Use a pin to reset through the aux port” – laughable.
I tried every tip and trick I could find. Still nothing. And I was burning through my data trying to find a solution that actually works.
The Real Fix: How to Reboot the Zealot P2 Bluetooth Speaker
Now here’s the real solution that actually worked for me—and will work for you too.
I remembered something.
I have a bad habit of absent-mindedly plugging cables into the wrong ports. On several occasions, I’ve accidentally jammed a charging cable into the USB-A port (the regular USB port) of the Zealot P2. When this happens, the speaker usually shuts off due to a short.
💡 That’s the trick.
Here’s exactly what to do:
- Grab a power bank.
- Use a USB-C to USB-A cable (USB-C end goes into the power bank, USB-A end goes into the speaker).
- Plug it in — into the USB-A port of the speaker, not the charging port.
The moment I did this, the Zealot P2 powered off instantly. It reset itself.
What Happened After?
I turned the speaker back on and this time, the Mode button worked again. Everything was back to normal. No more freezing. No more unresponsive buttons.
Apparently, this bug is common with Zealot P1 and P2 speakers. The firmware gets stuck, and some buttons just stop responding. It’s not a hardware problem—it’s just a glitch.
This USB-A “short trick” acts like a soft reset and snaps the speaker out of its frozen state.
Final Thoughts
If you ever run into this issue where your Zealot P2 freezes and won’t turn off or respond, don’t panic. You don’t need to take it to a repair shop or start opening the casing. You now know exactly how to reboot the Zealot P2 Bluetooth speaker with a simple USB cable and a power bank.
Save your time. Save your data. And please, share this fix with someone else—because nobody should suffer the way I did just to reset a Bluetooth speaker.
TL;DR – Quick Fix Recap
- Problem: Zealot P2 won’t turn off or respond
- Fix: Plug a USB-A cable from a power bank into the USB-A port of the speaker
- Result: Speaker powers off and resets itself
- Tested and confirmed ✅
The site is not longer monetized and I need to your help to keep it alive or it may not be here tomorrow.
Please Help Me Keep The Site OnlineWant more grounded articles like this? Follow Inquisitive Universe—where hype gets checked and specs get real.
- Subscribe to our YouTube channel
- Follow on Facebook
- Follow on WhatsApp
- Join our Telegram community
- Participate on Reddit
- Find us on Quora